![]() ![]() For the reversers, you would normally program a throttle button (or the button detent on the throttle axis, if you have one) to send repeated. For the P3D PMDG 737, you can assign the throttle in FSUIPC but without calibration. I am so confused, definitely something was done to the airplane and FSUIPC7 need an update or something. As I dont have the PMDG 737, it is difficult for me to advise on how the reversers work in that aircraft in MSFS. ![]() When I did a full left or right turn, the airplane just stop won’t move and I need to put a lot of thrust like full throttle to make it move, even thought my aircraft weight is almost empty. The plane handle like it was before I install FSUIPC7. Man… I have been tweaking, deleting, uninstall, install but same results. Now I did a rescan and this is the new output:ĭo I need to set something in this tab? the rudder section? Appreciate for the help manĪfter the update 1.13.16.0, when I twist my joystick left and right its finally captured back those numbers.īut still when taxiing on the runaway, a slight hard to the left or right will make the B787 stop again like before I was using FSUIPC7. Once this new update download is completed I will capture a screenshot and upload it in here. Sometime its captured those numbers “1638” and sometimes its not. My In/Out for some weird reasons it set back to 0 after I twist my joystick axis to left and right. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |